NetComm V110 - Manual (Page 59)

YML881Rev1 �11��� ��1���� ��11�� ���� �11��� ��1���� ��11�� ���� User Guide
www.netcomm.com.au 
Automatic Update Notify only: When newer firmware is available, the VoIP Gateway will only notify you by a
“BEEP BEEP BEEP” you when you pick up the phone. It will not automatically upgrade.
Automatic (Scheduling): When there is a newer firmware, it will update the firmware
automatically.
firmware file
Prefix The file prefix of the firmware
next update time Displays the next update or check time.
notify only Auto Update Procedure:
1. Power on the VoIP Gateway and it will check if there is any newer firmware available on the Server. When
there is a newer firmware, it will only notify you by “BEEP BEEP BEEP” after you pick up the phone.
2. Please press #190# and then hang up the phone to unlock the special key on keypad.
3. Please press #160# and then hang up the phone to ask NetComm ATA to update the firmware
immediately.
4. It takes around 7 minutes for updating the new firmware.
AUto UPdAte ProcedUreS:
1. Power on the NetComm ATA and reaches Next update time. It will check if there is any update firmware
is newer one on the Server. When there is a newer firmware, it’ll update the firmware automatically. It will
take around 7 minutes to update the firmware.
Be noted:
1. If the NetComm ATA is powered off and has passed the Next update time, it will not update the firmware
after you power on the NetComm ATA. It’ll only update when the NetComm ATA is power on and reaches
Next update time.
2. If you are on the phone and have a conversation to others by VoIP and the Next update time is passing, it
will update the firmware immediately after you hang up the phone.