National Instruments Eight-slot USB Chassis NI cDAQ-9172 - Manual (Page 13)

© National Instruments Corporation 13 NI cDAQ-9172 User Guide and Specifications
NI 9910 DIN-Rail Kit
The NI 9910 DIN-Rail Kit contains one clip for mounting the chassis on a
standard 35 mm DIN-Rail. To mount the chassis on a DIN-Rail, fasten the
DIN-Rail clip to the chassis using a number 2 Phillips screwdriver and
two M4
× 17 screws. The screws are included in the DIN-Rail kit. Make
sure the DIN-Rail kit is installed as illustrated in Figure 4, with the larger
lip of the DIN-RAIL positioned up. When the DIN-Rail kit is properly
installed, the NI cDAQ-9172 chassis is centered on the DIN-Rail.
Caution Remove the I/O modules before removing the chassis from the DIN-Rail.
Figure 4. DIN-Rail Installation on the NI cDAQ-9172
NI 9905 Panel Mount Kit
To mount the chassis on a panel, align the chassis on the panel mount
accessory. Attach the chassis to the panel mount kit using two M4
× 17
screws (as shown in Figure 5). National Instruments provides these screws
with the panel mount kit. You must use these screws because they are the
correct depth and thread for the panel. These slots in the panel mount kit