NetComm HSPA 7.2 MBPS WI-FI ROUTER 3G9W - Manual (Page 45)

3G9W - HSPA 7.2Mbps Wi-Fi Router USER GUIDE
YML902 – 45
7.1 Local Area Network (LAN)
This screen allows you to configure the Local Area Network (LAN) interface on your Router.
See the field descriptions below for more details.
Option Description
IP Address Enter the IP address for the LAN interface
Subnet Mask Enter the subnet mask for the LAN interface
Enable UPnP Tick the box to enable Universal Plug and Play
Enable Internet Group
Management Protocol
(IGMP) Snooping
Enable by ticking the box
Standard Mode: In standard mode, multicast traffic will flood to all bridge ports when
no client subscribes to a multicast group.
Blocking Mode: In blocking mode, the multicast data traffic will be blocked. When
there are no client subscriptions to a multicast group, it will not flood to the bridge ports.
Dynamic Host
Configuration Protocol
(DHCP) Server
Select Enable DHCP server and enter your starting and ending IP addresses and
the lease time. This setting configures the router to automatically assign IP, default
gateway and DNS server addresses to every DHCP client on your LAN
Configure a second IP address by ticking the checkbox shown below and enter the following information:
IP Address: Enter the secondary IP address for the LAN interface.
Subnet Mask: Enter the secondary subnet mask for the LAN interface.
NOTE: The Save button saves new settings to allow continued configuration, while the Save/Reboot button not only saves new settings
but also reboots the device to apply the new configuration (i.e. all new settings).