Nortel Networks ICS 6.1 - Manual (Page 112)

103
P0603536 02 Modular ICS 6.1 Programming Record
•••• Protocol
•••• PrivNetId
••• Discon timer Specify the duration of an Open Switch Interval for a Trunk Cartridge.
••• Answer timer Select the minimum duration, in seconds, of an answer signal before a call is
considered to be answered, for an E&M trunk cartridge.
•• CO fail Select the carrier failure standard used by your T1 service provider.
This setting only appears for DTIs.
•• I/F levels Interface levels defaults to the ISDN loss plan setting.
Check with your telecommunications service provider to find out the I/F level
of your connection:
• digital network loss treatment (ISDN I/F levels)
• analog network loss treatment (PSTN I/F levels)
•• Framing Use to select the framing format used by your T1 service provider.
This setting only appears for DTIs.
•• Internal CSU Use to turn the internal TI channel service on or off.
The channel service unit gathers performance statistics for your T1 lines.
•• CSU line bld Use to set the gain level of the transmitted signal.
This setting only appears for DTIs that have their internal CSU turned on.
•• DSX1 bld Use to set the distance between the ICS and an external channel service unit.
This setting only appears for DTIs that have their internal CSU set to Off.
•• Line coding Select the standard used by your T1 service provider for encoding signals on
the T1 lines.
•• ClockSrc Determine the type of clock source.
••• Loops View the loops on a BRI Card.
••• Loop nnn View the settings for a particular loop on a BRI Card.
•••• Type View or change the loop type.
•••• Sampling Select the sampling used by an S-loop.
•••• DNs on Loop Assign the ISDN DNs that use this loop.
••••• Assign DNs Enter ISDN DNs for each S-loop or LT loop.
••••• Show DN:_ Indicate whether or not the DN is assigned to a loop.
••••• Loop DN:_ Select the main ISDN DN, if any, for the loop.
••• SPID1 Enter the SPID supplied by your service provider.
••• # of B-channls Select the number of B-channels that are associated with the SPID.
••• Network DNs Enter the Network DNs that are associated with the SPID.
A Network ISDN DN can be assigned to more than one SPID.
•••• Call type Select the Call type used with the Network DN.
For each ISDN DN, use only one of each of the Voice and Data call type
settings, or a single Both call type setting.