Nortel Networks ICS 6.1 - Manual (Page 90)

81
P0603536 02 Modular ICS 6.1 Programming Record
Glossary of programming headings and settings
This section presents the programming hierarchy in the Norstar Modular ICS/Modular ICS-XC interface. The dots each represent a
level below the top level
Top Level Level 1
•
Level 2
••
Level 3
•••
Below the
3rd level
••••
•••••
••••••
•••••••
Menu item Description
Profile
(use only at system startup)
Change on non-North American systems, only!
Use this command to choose a profile that reflects the trunk card profile for
the specific country.
Use Profile password.
WARNING: Never use this command after Startup has been run.
Dialpad
(use only at system startup)
Use this command to select the dialpad layout you require. This is a system-
wide setting.
Use Dialpad access.
Startup
(use only for initial configuration at system startup)
Use this command to select the default information specific to your system.
Use Startup access.
This command is only available immediately after startup of the KSU.
• Template Select the template to assign the default values for the system.
• Start DN Enter between three and seven digits to indicate the first DN of the range you
plan to use.
The length of this entry also defines the default DN length and the default
Received number length.
Note: If the first digit of a DN is the same as any of the follow codes, the
system sets these codes to None:
• Direct-dial digit
• Call Park prefix
• first digit of a line pool access code