Nortel Networks ICS 6.1 - Manual (Page 98)

89
P0603536 02 Modular ICS 6.1 Programming Record
••• Auto privacy Select whether a line will be private to the individual on a call, or whether it
can be shared by other users while a call is in progress. The Privacy setting
can be suspended for individual calls using the privacy feature (
²¡Ü
).
••• Trunk mode Select whether the line operates with disconnect supervision. Auto answer
and DISA lines must be supervised. This setting does not appear for target
lines.
••• Ans mode Select whether the line will be answered manually, the normal call answering
method, or automatically by the system. Auto answer allows remote access
to your Norstar system. This setting only appears if Trunk mode is
supervised.
••• Ans with DISA Select whether a line programmed for auto answer will be answered with
Direct Inward System Access (DISA) or with system dial tone. This setting
only appears if Ans mode is Auto. This setting does not appear for target
lines.
••• Link time Select the duration of a signal, such as recall or flash, when a signal is
required to access a feature through a remote system.
••• Link at CO Select whether the system applies the restrictions on outgoing calls to the
digits dialed after the Link signal (a host signalling option).
••• Aux. ringer Select whether an auxiliary ringer, if installed, will ring for incoming calls on
this specific line.
••• Full AutoHold Select whether an idle line will be put on hold when another line is selected.
This setting does not appear for target lines.
••• Distinct Ring Choose whether the line will have a distinctive ring pattern.
••• LossPkg Select the appropriate loss/gain and impedance package for analog loop
lines only. Select the package based on the terminating switch type (PBX or
CO), and the distance from the switch (Short, Medium or Long). This setting
only appears if Cd1-KSU is Loop. It does not appear for target lines.
••• Rec’d # Enter the Received number for this target line. When the system
automatically answers an incoming call on auto-answer Loopstart or digital
lines:
• it collects the number of digits specified by the Rec’d # length setting
• it matches these digits to a Received number
• it routes the call to the appropriate target line.
A Received number cannot be the same as, or be the start digits, of a line pool
access code, a destination code, the DISA DN, or the Auto DN.
••• Signal Select the signal type for an E&M or DID line to match the signal type
programmed for the trunk at the other switch.
••• ANI number Select whether the telephone number of the caller will be collected for this
E&M or DID line. The digits can then be displayed on Norstar telephones as
part of Call Information services.
••• DNIS number Select whether the digits dialed by an external caller on this E&M or DID line
will be collected.
••• Gain Select the appropriate gain level for this E&M or DID line.
•• Name Enter a name for a line that is up to seven characters long. This name defaults
to the line number.
•• Restrictions Allows you to create and assign restriction filters. These filters control what
kind of calls a user can make on this line.