NetComm IP DSLAM - Manual (Page 64)

NetComm NCT240 Management Guide Release 1.0
Save
This command saves all system configurations to nonvolatile memory. You must
use this command to save any configuration changes that you make, otherwise the
NCT240 will ignore the changes. Save your changes after each configuration session.
Syntax: save
¾ use this command to save your configuration when you are done with a
configuration session
command usage:
BAS/config>save
Do you want to save the current configuration? (y/n)
save command
Restore
This command will reload the last correct configuration in the system. Using this
command you can easily back to the latest successful configuration
Syntax: restore <current| last| factory>
¾ current – recover by the current configuration
¾ last – recover the by last saved configuration
¾ factory – recover by the factory default configuration
Command usage:
BAS/config>restore
Recover the specified configuration
Usage:
restore <current| last| factory>
current Recover by the current configuration.
last Recover by the last saved configuration.
factory Recover by the factory default configuration.
restore command
63