Figure 4-28. gpctr0_gate signal timing, Gpctr0_out signal, Figure 4-29. gpctr0_out signal timing – National Instruments NI PCI-6110 User Manual
Page 62: Gpctr0_out signal -32
Chapter 4
Connecting Signals
4-32
ni.com
As an output, GPCTR0_GATE reflects the actual gate signal connected to
general-purpose counter 0, even if the gate is being externally generated by
another PFI. This output is set to high-impedance at startup.
Figure 4-28 shows the timing requirements for the GPCTR0_GATE signal.
Figure 4-28. GPCTR0_GATE Signal Timing
GPCTR0_OUT Signal
This signal is available only as an output on the GPCTR0_OUT pin.
The GPCTR0_OUT signal reflects the terminal count (TC) of
general-purpose counter 0. You have two software-selectable output
options—pulse on TC and toggle output polarity on TC. The output
polarity is software-selectable for both options. This output is set to
high-impedance at startup. Figure 4-29 shows the timing of
GPCTR0_OUT.
Figure 4-29. GPCTR0_OUT Signal Timing
Rising-Edge
Polarity
Falling-Edge
Polarity
t
w
= 10 ns minimum
t
w
GPCTR0_SOURCE
GPCTR0_OUT
(Pulse on TC)
GPCTR0_OUT
(Toggle Output on TC)
TC