Nortel Networks COOLPIX P7000 - Manual (Page 198)

184
Setup Menu
Basi
c Came
ra Setup
Built-in ND Filter
When the camera’s built-in ND filter is used, the amount of light that enters the
camera while shooting can be reduced in three steps. Use in situations such as when
overexposure results from the subject being too bright. Set whether or not to use the
built-in ND filter to reduce the light in the following shooting modes.
•
O (low noise night) mode
•
A, B, C and D modes (including E, F and N modes)
In shooting modes other than the above, the on/off setting of the built-in ND filter
is controlled automatically according to the shooting mode and shooting
conditions, regardless of Built-in ND filter setting.
The setting for the built-in ND filter is shown by an icon displayed on the monitor
during shooting (
A6). Nothing is displayed when the setting is Off, A (auto),
scene or movie mode.
C
Effects of the Built-in ND Filter
Using the filter may enable the shooting of subjects that are too bright without overexposing the
image. It can also be used in situations such as when you want to slow down the shutter speed at a
low aperture value.
For example, at a shutter speed of 1/2000 second with the correct exposure, if the ND filter is used to
reduce the light in three steps, the speed can be changed to 1/250 second without changing the
aperture value.
Press the d button M z (Setup menu) (A168) M Built-in ND filter
On
Use the ND filter to reduce the light.
Auto
In mode O (low noise night) or A (Programmed auto), when the subject is too
bright and the exposure range is exceeded, reduce the light automatically with the
ND filter.
• In shooting modes
B, C or D, the ND filter is disabled.
Off (default setting)
The ND filter is not used.