Nortel Networks COOLPIX P7000 - Manual (Page 219)

205
T
e
ch
n
ical
No
te
s an
d I
n
de
x
Error Messages
The following table lists the error messages and other warnings displayed on the
monitor, as well as the solutions for dealing with them.
Display Description Solution A
O
(blinks)
Clock not set. Set clock. 170
B Battery is running low. Prepare to charge or change battery. 16, 18
N
Battery exhausted.
Battery exhausted. Charge or change battery. 16, 18
P
Battery temperature high Battery temperature is
high.
Turn off camera, and allow battery to
cool down before resuming use. Five
seconds after this message appears,
the monitor is turned off, and the
power-on lamp, the AF lamp and the
flash lamp flicker. After the lamps
blink for three minutes, the camera
turns off automatically, but you can
also press the power switch to turn it
off manually.
19
P
Please wait for the
camera to finish
recording. Camera cannot
perform other
operations until
recording is complete.
Wait until message clears from
display automatically when
recording is complete.
–
N
Memory card is write
protected.
Write-protect switch is
in “lock” position. Slide the write-protect switch to
“write” position.
23
P
This card cannot be used. Error accessing
memory card.
• Use an approved card.
• Check that connectors are clean.
• Confirm that memory card is
correctly inserted.
221
22
22
P
This card cannot be read.
P
Card is not formatted.
Format card?
Yes
No
Memory card has not
been formatted for use
in this camera.
All data stored on the memory
card is deleted when formatted. If
there is any data on the card that
you want to keep, select No, and
backup the data to a computer
before formatting the memory card.
To format the memory card, select
Yes and press the
k button.
23