Roland RG-7 - Manual (Page 61)

60
Chapter 3. Performance
■ Adjusting the Sound to Achieve the Preferred
Tone Quality (Equalizer)
The RG-7 features a built-in, three-band digital equalizer.
An equalizer boosts or cuts specific sound pitches (frequency ranges) to adjust the
sound balance for the overall performance. For example, you can boost the highs to
get a crisper sound, or boost the low end for a more powerful sound.
You can also adjust the sound to compensate for the acoustical characteristics of the
performance space.
If raising the values for separate frequencies causes the sound to distort, you can use
the “Master Level” (see below) to control such distortion.
1
Press the [Function] (Exit) button, getting its indicator to light.
2
Press the [Song] (Select -) button or [ ] (Select +) button to display
the EQUALIZER screen.
fig.
3
Press the [Song] (Select -) button or [ ] (Select +) button so that the
value for the range you want to set is flashing.
fig.
4
Press the [ ] (Value -) button or [ ] (Value +) button to adjust the
range and the overall level.
Value: -60 – 0 – +60
5
Press the [Function] (Exit) button so the indicator goes out.
Value Description
Master
(Master Level)
You can temper the distortion in the sound by lowering
the level. Raising the level too much may cause the sound
to become distorted.
L (Low)
Low-frequency range. This is the range of frequencies for
instruments like drums, bass, organ, guitar and strings.
M (Middle)
Midrange. This is the range of frequencies where most
instrument sounds are concentrated.
H (High)
High-frequency range. These frequencies add brilliance to
the sound.
You can save this setting in the
RG-7’s memory using the
Memory Backup function (p.
72).
RG-7_e.book 60 ページ ２００５年２月１４日 月曜日 午前９時４５分