Roland Sonar V-Studio VS-700 - Manual (Page 124)

124
Creating a Patch
● Changing the Depth of Frequency Modulation
for FXM
FXM DEPTH
● Changing Specific Multi-Effects Parameters
MFX CTRL1–4: Change the parameter that was specified by
MFX Control 1–4 Assign parameter.
If you have not made the necessary settings for using
the multi-effect, the multi-effect will not be applied
even if you attempt to control it as a Matrix Control
destination.
● If you’re not using Matrix Control
OFF: Matrix Control will not be used.
CTRL Sens 1–4 (Matrix Control Sens 1–4)
Sets the amount of the Matrix Control’s effect that is applied.
If you wish to modify the selected parameter in a positive (+)
direction – i.e., a higher value, toward the right, or faster etc. –
from its current setting, select a positive (+) value. If you wish
to modify the selected parameter in a negative (-) direction –
i.e., a lower value, toward the left, or slower etc. – from its
current setting, select a negative (-) value. For either positive
or negative settings, greater absolute values will allow
greater amounts of change. Set this to “0” if you don’t want
to apply the effect.
Value: -63– +63
CTRL Tone 1–4 (Tone Control Switch 1–4)
Matrix Control Tone selects the tone to which the effect is
applied when using the Matrix Control.
Value
OFF: The effect will not be applied.
ON: The effect will be applied.
REVS: The effect will be applied in reverse.
VS-700_r_e.book 124 ページ ２００８年１１月２０日 木曜日 午後２時２８分