Roland Sonar V-Studio VS-700 - Manual (Page 138)

138
Creating a Performance
Reverb Send Level (Part Reverb Send Level)
Sets the level of the signal sent to reverb for each part.
Value: 0–127
Cutoff Offset
Adjusts the cutoff frequency for the patch or rhythm set
assigned to a part.
Value: -64– +63
Patches also have a Cutoff Offset setting (p. 98). The final
Cutoff frequency value is the sum of the tone Cutoff
Frequency value and the patch and part Cutoff Offset
values. If the tone’s cutoff frequency is already set to
“127” (maximum), there will be no change produced by
setting the Cutoff Offset to a positive value.
Resonance Offset
Adjusts the Resonance for the patch or rhythm set assigned
to a part.
Value: -64– +63
Patches also have a Resonance Offset setting (p. 98). The
final Resonance value is the sum of the tone Resonance
value and the patch and part Resonance Offset values. If
the tone’s resonance is already set to “127” (maximum),
there will be no change produced by setting the
resonance offset to a positive value.
Attack Time Offset
Adjusts the TVA/TVF Envelope Attack Time for the patch or
rhythm set assigned to a part.
Value: -64– +63
Patches also contain the Attack Time Offset setting (p.
98). The final TVA Envelope attack time value is
therefore the sum of the tone’s TVA Envelope Time 1
setting, the patch’s Attack Time Offset, and the part’s
Attack Time Offset. If the tone’s Time 1 parameter is
already set to “127” (maximum), there will be no change
produced by setting the Attack Time Offset to a positive
value.The same applies to the TVF envelope.
Release Time Offset
Adjusts the TVA/TVF Envelope Release Time for the patch or
rhythm set assigned to a part.
Value: -64– +63
Patches also contain a Release Time Offset setting (p.
99). The final TVA Envelope release time value is
therefore the sum of the tone’s TVA Envelope Time 4
setting, the patch’s Release Time Offset, and the part’s
Release Time Offset. If the tone’s Time 4 parameter is set
to “127” (maximum), there will be no change in the
Release Time Offset, even when this is set to a positive
value.The same applies to the TVF envelope.
Decay Time Offset
Adjusts the TVA/TVF Envelope Decay Time for the patch or
rhythm set assigned to a part.
Value: -64– +63
VS-700_r_e.book 138 ページ ２００８年１１月２０日 木曜日 午後２時２８分