Roland Sonar V-Studio VS-700 - Manual (Page 36)

36
CHANNEL STRIP Section
Use the [SEL] button to activate the CHANNEL STRIP CONTROL section for the selected channel, which allows you to
control EQ and Send parameters for that channel.
The eight [SEL] buttons are mutually exclusive, so only one channel at a time can be selected. When enabled, the
[SEL] button stays lit.
The modifier buttons (p. 67) can be used to extend the functions as follows.
The [SEL] button is not bi-directional. Changing the current track in SONAR will not change the selected
channel on the VS-700C Console.
fig.4.eps
Strip Select (SEL)
Button Explanation
Default (no modifier button)
Activates the CHANNEL STRIP CONTROL section for the selected channel. Also
sets the current track in SONAR if FADER VIEW is assigned to TRACK.
CTRL+SEL
Enable Plug-in mode. For more information, refer to “Controlling Plug-ins
from the VS-700C Console” (p. 74).
SHIFT+SEL
Locks/unlocks the channel strip to the corresponding track/bus in SONAR.
(p. 46)
COMMAND+SEL
Toggles a global enable state for locking. If you have strips locked, you can
disable and re-enable locking and the same strips will be locked.
VS-700_r_e.book 36 ページ ２００８年１１月２０日 木曜日 午後２時２８分