Roland Sonar V-Studio VS-700 - Manual (Page 18)

18
Panel Descriptions
fig.panel-vs-700c-rear.eps
A. TO I/O Connector
Use the dedicated cable to connect the VS-700C Console to the VS-700R I/O unit. Do not use any cable other than the
dedicated cable.
➔ “Connecting Your Computer and Sound Reinforcement Equipment” (p. 27)
B. USB Connector
By connecting the USB connector of the console directly to your computer (without using the VS-700R I/O unit), you
can use the console as a control surface.
➔ “Using only the VS-700C Console (Standalone Mode)” (p. 164)
C. SETTING DIP Switches
Change the settings of these switches if you have connected the console directly to your computer (without using
the VS-700R I/O unit).
➔ “Using only the VS-700C Console (Standalone Mode)” (p. 164)
D. FOOT SW Jacks
Here you can connect two foot switches.
➔ “Starting/Stopping Playback With a Foot Switch” (p. 55)
E. LCD CONTRAST Knob
This adjusts the brightness of the LCD display.
F. AC Inlet
Connect the included power cord to this inlet.
➔ “Connecting the Power Cord” (p. 26)
G. POWER ON Switch
Press to turn the power on/off.
➔ “Turning the Power On” (p. 28)
Rear Panel
A B C D E F G
VS-700_r_e.book 18 ページ ２００８年１１月２０日 木曜日 午後２時２８分