Changing how a rhythm tone is sounded (wmt), Parameter (p. 128) – Roland Sonar V-Studio VS-700 User Manual

Page 128

Advertising
background image

128

Creating a Rhythm Set

Wave Level

You can set the volume of the waveform.

Value:

0–127

The volume level of each rhythm tone is set with the

Tone Level parameter; the volume levels of the entire

rhythm set is set with the Rhythm Level parameter (p.

125).

Wave Pan

This specifies the pan of the waveform. “L64” is far left, “0” is

center, and “63R” is far right.

Value:

L63–0–63R

Wave Rnd Pan Sw (Wave Random Pan Switch)

Use this setting to cause the waveform’s panning to change

randomly each time a key is pressed (ON) or not (OFF).

Value:

OFF,

ON

* The range of the panning change is set by the Rnd Pan Depth

parameter (p. 134).

Wave Alter Pan Sw (Wave Alternate Pan Switch)

This setting causes panning of the waveform to be alternated

between left and right each time a key is pressed. Set

Alternate Pan Switch to “ON” to pan the Wave according to

the Alter Pan Depth parameter (p. 134) settings, or to “REV”

when you want the panning reversed. If you do not want the

panning to change each time a key is pressed, set this to

“OFF.”

Value:

OFF, ON, REV

The WMT (Wave Mix Table) uses key velocity to control the

four waveforms assigned to the rhythm tone.

Rhythm WMT

WMT Velocity Control (Velocity Control Switch)

WMT Velocity Control determines whether a different rhythm

tone is played (ON) or not (OFF) depending on the force with

which the key is played (velocity).

When set to “RND,” the rhythm set’s constituent rhythm

tones will sound randomly, regardless of any Velocity

messages.

Value:

OFF, ON, RANDOM

Velo Fade Lower (Velocity Fade Width Lower)

This determines what will happen to the tone’s level when

the tone is played at a velocity lower than its specified

velocity range. Higher settings produce a more gradual

change in volume. If you want notes played outside the

specified key velocity range to not be sounded at all, set this

to “0.”

Value:

0–127

Velo Range Lower (Velocity Range Lower)

This sets the lowest velocity at which the waveform will

sound. Make these settings when you want different

waveforms to sound in response to notes played at different

strengths.

Value:

1–UPPER

Changing How a Rhythm Tone is
Sounded (WMT)

VS-700_r_e.book 128 ページ 2008年11月20日 木曜日 午後2時28分

Advertising