Ricoh Aficio RPCS MP 2000 - Manual (Page 23)

When You Cannot Make Copies As Wanted
17
2
❖ Duplex (Type 2 only)
When Memory Is Full
This section describes likely causes of and possible solutions for problems relat-
ed to full memory.
Problem Cause Solution
Cannot print in duplex
mode. You may have loaded paper on
the bypass tray. Remove paper loaded on the by-
pass tray. Load paper in Tray 1 - 4.
Cannot print in duplex
mode. You have loaded paper exceeding
90 g/m
2 .
Change the paper.
Cannot print in duplex
mode. You have selected a tray that is set
to [Off] for duplex printing in
[Tray Paper Settings]
under [System
Settings] .
Select a paper tray in [Tray Paper
Settings]
under [System Settings],
and then press [OK]. Then, select
[No Display (Plain Paper)]
or [Recy-
cled Paper] for Paper Type, press
[Duplex] , and then select [On]. See
“Tray Paper Settings”, General
Settings Guide.
Copies are not in du-
plex order. You placed the originals in the in-
correct order. When placing a stack of originals
in the ADF or ARDF, the last page
should be on the bottom.
If you place an original on the ex-
posure glass, start with the first
page to be copied.
When using Duplex,
copy is made Top to
Bottom even though
[Top to Top]
is selected.
You placed the originals in the
wrong orientation. Place the original in the correct
orientation. See “Original Orien-
tation”, Copy Reference.
Parts of the original im-
age are not copied. The margin is too wide. Set a narrower margin with User
Tools. See “User Tools Menu (Copi-
er Features)”, Copy Reference.
Message Cause Solution
Press [Resume]
to scan and copy
remaining orig-
inals.
The machine checks if the remain-
ing originals should be copied, af-
ter the scanned original has been
printed. To continue copying, remove all
copies, and then press [Resume].
To stop copying, press [Stop].