Ricoh 3030 - Manual (Page 29)

Canceling a Memory Transmission
21
2
Canceling a Memory Transmission
You can cancel the mode using the same
procedure in the following cases:
• Fax Destination, Internet Fax Des-
tination, and IP-Fax Destination
are specified simultaneously.
• Only either Internet Fax Destination
or IP-Fax Destination is specified.
Before the Original Is Scanned
Use this procedure to cancel a trans-
mission before pressing the {Start} key.
A
Press the {Clear Modes} key.
Note
❒ When originals are placed into the
ADF, you can cancel transmis-
sion simply by removing them.
While the Original Is Being
Scanned
Use this procedure to cancel a trans-
mission after pressing the {Start} key.
A
Press the {Clear/Stop} key.
The machine stops scanning.
Note
❒ You can also cancel scanning by
pressing [Stop Scanning].
❒ Scanning may be completed while
you are performing the cancel
operation.
While the Original Is Being
Transmitted
Note
❒ If the transmission finishes while
you are carrying out this proce-
dure, it will not be canceled.
❒ If you cancel a document while it is
being sent, the transmission is halt-
ed as soon as you finish the cancel-
lation procedure. However, some
pages of the document may al-
ready have been sent and received
at the other end.
A
Press the {Clear/Stop} key.
Note
❒ You can also cancel a Memory
Transmission by pressing [Change
/ Stop TX File]
.
ZLBS050N
RussianC4-AE_Combine-F_FM.book Page 21 Friday, April 15, 2005 11:13 AM