Ricoh Aficio AP610i - Manual (Page 32)

Paper and Other Media
32
Loading Envelopes
As there are many kinds of envelopes, be sure to check if those to be used are
supported by this printer.
For more information about envelopes, see p.12 “Envelopes” .
❒ Even if the optional envelope feeder is not installed, you can select envelope
sizes for Tray 2 and Tray 3 using the control panel. However, you cannot load
envelopes until the optional envelop feeder unit is installed.
❒ To install the envelope feeder unit, the optional paper feed unit must be in-
stalled. See “Attaching Envelope Feeder Type 610”, Setup Guide.
Loading envelopes onto the Bypass Tray
With the bypass tray, you can load up to 10 envelopes at the same time. For
more information about envelopes, see
p.12 “Envelopes” .
To open and close the bypass tray, see p.25 “Opening and Closing the By-
pass Tray” .
A
Load envelopes until they stop, with the print side up and the sides of
the flaps on the left as shown below.
❒ Confirm that the envelope flaps are securely folded down, and that there is
no air inside the envelopes.
❒ Confirm that the top of the stack is not higher than the limit mark on the side
guides.
❒ Do not push the stack of envelopes with too much force.
B
Slide the side guides against the edge of the envelope stack.