Troubleshooting, Error & status messages on the control panel – Ricoh Aficio AP610i User Manual

Page 75

Advertising
background image

G1168611A_1.10

Copyright ©

2004, 2005

75

Troubleshooting

Error & Status Messages on the Control
Panel

This section explains what the messages that appear on the control panel mean
and what to do when a particular message appears.

Messages (in alphabetical order)

Messages/Second
messages

Description

Solution

Call Service: EC

Power Off On

/ If Error Reoccur

Call Service

A communication error sent
from the engine to the controller
has occurred in the printer.

Turn the power off, and then on. If the
message appears again, call your
sales or service representative.

Cannot check

Signal in Ad hoc

An attempt to check the radio
signal was made while the
communication mode was set
to [802.11 Ad hoc] in the interface
settings.

To check the radio signal , select In-
frastructure in the communication
mode settings.

Change Setting

Tray #

/ Paper Size:

Paper Type:

The paper size and type setting
in the tray differs from that of
actual paper size and type in
the tray.

#: tray number

Load paper of the selected size in the
tray, and then change the paper size
setting with the control panel. Or,
press {Form Feed}, and then select the
tray using the control panel. Or, press
{Job Reset} to cancel the print job.

You can make to setting to print disre-
garding the error message.

Close Duplex

Unit Cover

The cover of the optional du-
plex unit is open.

Close the cover of the optional Duplex
Unit.

Close

Front Cover

The front cover is open.

Close the front cover by pressing the
left and right side indentations.

Close Rear/Paper

Exit Cover

The paper exit cover or the rear
cover is open.

Close the paper exit cover or the rear
cover.

DHCP assigned

Cannot change

An attempt to change the IP ad-
dress, subnet mask or gateway
address was made while DHCP
was set to [On].

Make the change after setting DHCP
to [Off].

Energy Save Mode

The printer is in Energy Saver
mode.

No action required.

Error: Enter 5

or 13 characters

An ID with an invalid number of
digits was entered for the WEP
key.

Enter the correct number of digits for
the WEP key.

Advertising
This manual is related to the following products: