Ricoh 4506 - Manual (Page 140)

Area Editing (Option)
128
4
Notes for Designating Areas
The number of the points, areas, and groups that can be designated
Note
❒ Maximum number of points: 500
❒ In Right Angle Polygon mode, Polygon mode, or Line mode, the maximum
number of points for one area is 30.
❒ The number of areas that can be designated is as follows:
• Rectangle mode: maximum 250 areas
• Right Angle Polygon mode, Polygon mode, Line mode: 500 points maxi-
mum. For example, if 10 points are designated for each area, the maximum
number of areas that can be designated is 50.
• Closed Loop mode, Multi-Closed Loop mode: maximum 500 areas
❒ Maximum number of groups: 20 (“Group” means a set of areas that you want
to do same editions.)
❒ If you want to designate area shape like an acute angle by using Polygon
mode or Line mode, see the following instructions.
• Use two separate lines to create angle(A).
• The first designated point(1) and the next designate point(3) should have
distance of more than 4mm(0.2")(B).
*:4mm(0.2”)
Note
❒ Do not designate an area or line which overlaps part of another area or line.
If an area overlaps another one, the job settings specified last will be applied
to the overlapped portion or those areas might not be copied.