Ricoh 4506 - Manual (Page 59)

Basic Procedure
47
2
❒ You cannot use this function for OHP transparencies, translucent paper, ad-
hesive labels and postcards.
❒ Do not use copy paper that has been already copied onto by other machines.
❒ If the copy paper is bent, correct it before setting paper in the bypass tray. If
the bend is not corrected, a paper misfeed might occur.
A
Open the bypass tray.
B
Insert the paper into the bypass tray.
Note
❒ Make sure the front side (the side that has been copied onto) faces down.
C
Press the [Normal] or [Thick] key.
D
Press the [
K K K K/ L L L L] key to select paper orientation.
E
Press the [Duplex Back] key.
Note
❒ To copy onto custom size paper, press the [Custom Size] key and select or
enter the size. For details,
⇒ P.41 “Copying onto custom size paper with the
bypass tray”.
F
Press the [OK] key.
G
Adjust the paper guides to the paper size.
Note
❒ Make sure that the paper guides match the paper size. If the paper guides
are not adjusted to the paper size properly, paper might be skewed or a pa-
per misfeed might occur.
H
Set your originals, then press the
{{{{Start}}}} key.
copy21.tif