ZANKER ZKK 9008 - Manual (Page 12)

Control panel
1 2
1 Light switch
2 Temperature regulator
Switching on
Insert the plug into the wall socket.
Turn the Temperature setting regulator clockwise to a
medium setting.
Switching off
To turn off the appliance, turn the Temperature regula-
tor to the "O" position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings
to obtain the minimum coldness.
• turn the Temperature regulator toward higher set-
tings to obtain the maximum coldness.
A medium setting is generally the most suitable.
However, the exact setting should be chosen keeping
in mind that the temperature inside the appliance de-
pends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Important! If the ambient temperature is high or the
appliance is fully loaded, and the appliance is set to the
lowest temperatures, it may run continuously causing
frost to form on the rear wall. In this case the dial must
be set to a higher temperature to allow automatic
defrosting and therefore reduced energy consumption.
First use
Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm water
and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly.
Important! Do not use detergents or abrasive powders,
as these will damage the finish.
12