Subaru Robin Power Products RG2800I - Manual (Page 55)

– 52 –
(4) Wind the spiral spring.
-1 Holding the case, turn the reel five turns in
counter-clockwise.
-2 Fix the reel in the position that the rope hole of
reel aligns with the rope guide.
(5) Inserting the rope. (this should be done by two people)
-1 Thread the rope end through the rope guide and
the rope hole of the reel, and pull 20cm out from
the reel.
-2 Tight the end of the rope.
-3 Fix the rope end to the reel.
-4 Hold the rope at the distance 50cm from the rope
guide. Hold securely.
-5 Gently release the reel and have it wind the rope
on the reel until the knot reaches the rope guide.
Five turns in counter-clockwise
About 20cm
About 10mm
Caution:
Do not release the pressure to hold the reel
while winding the spiral spring.
The spring force is strong and cause sudden
rewinding if you release the pressure.
Assembly is completed.
These are the disassembly and assembly procedures, please be sure to review the following item checklist to
insure that the parts securely installed.