Subaru Robin Power Products RG2800I - Manual (Page 59)

– 56 –
Check the gasoline
in the tank
Add gasoline
Check the oil level
Confirm of the oil sensor
Change Oil sensor
Add oil (up to the
rated volume)
Open
the cock
Clean,
change
the filter
Yes
None
Oil warning lamp turns on
when the recoil is pulled
warning
lamp is on
Fuel cock is in
the ON position
Yes
No
No Gasoline leaks when the
carburetor drain is loosened
Yes
Check for
gasoline deterioration
Good
Deteriorated
Remove the spark plug
and check the electrode
Wet
Dry
Attach the plug to the plug
cap, and check for sparks
by pulling the recoil starter
Good Sparks
No or
poor sparks
Valve clearance adjustment
Check the compression
at the spark plug hole
by pulling recoil starter
Poor compression
Resistance
value
0
Engine does not start (Start failure)
E/g
GND
Tester
Change
gasoline
Blockage of the fuel passage or
jets of carburotor
Check for dirty electrodes, or gap
Check the connection of coupler,
high tension cord and spark plug cap
Change the Inverter unit
No
Low
Good
No continuity