Subaru Robin Power Products RG2800I - Manual (Page 56)

– 53 –
3) Checking items after assembly
(1) Try to pull the starter handle for 2 to 3 times.
(a)When the starter handle is difficult to pull, please make sure the parts, etc., are installed in the right direction.
(b)When the ratchet does not operate, please re-check if there are any missing parts such as the spring.
(2) Pull the starter handle and try to pull the starter rope out to the limit.
(a)When the starter rope does not return smoothly, or the starter handle is hangs down loosely, please add
grease or mobile oil in the rotating and friction parts.
If it still does not work, rewind 1~2 times.
(In that case, confirm that the spring is not under pressure by following the previous procedure.)
(b)Please re-assemble from the beginning if there was the sound when the spring was removed and the starter
rope does not re-winded into the reel.
4) When . . .
(1)The spring pops out
(a)Hook the end hook of the spring to the notched
part of the reel, and attach the spring, applying
pressure with your fingers so that it isn’t released
from the groove. (Please wear gloves)
(b)Hook the inside hook of the spring to the claw of
the starter case while turning.
Please refer to assembly procedures.
Reel Spiral spring
(2) Oil refill
At the end of the season or when disassembling, add
grease (preferably one that is heat resistant, if
possible) or mobile oil to rotation parts, friction parts,
and the spring.