Oce North America TDS700 - Manual (Page 18)

18 Chapter 2 Walk-up user
Turn on and off the Océ TDS700
Illustration
[9]
[9] On/off switch at the rear of the printer
Turn on and off the printer
1. Set the On/off switch at the rear of the printer to position ‘1’. The green LED turns
on. The message Ready to print appears on the printer operator panel.
Note: You must separately switch on the controller that is located inside the printer.
2. Set the On/off switch at the rear of the printer to position ‘0’. This action only turns
off the printer.
Note: Before you turn off the printer, make sure that the printer is not printing a job.