Oce North America TDS700 - Manual (Page 31)

31
Load rolls of media
3. Remove the roll holder from the paper roll drawer.
4. Press the green knob inside the roll holder (on the right side) to release the locking
mechanism see figure below and remove the core from the holder.
[22]
[22] Press the knob
5. Slide the roll holder in the new roll of material while pressing the green knob.
6. Align the roll with the appropriate size indicator on the roll holder and release the
locking mechanism. This line has to be completely visible.
7. Use both hands to place the holder in the roll drawer.
[23]
[23] Position the media
8. Use both hands to slide the material under the metal paper guide until it makes
contact, as shown in the above figure.
Note: When the media is particularly curled it may be somewhat difficult to slide
the material under the paper guide. In that case you can slightly fold back the top
few centimetres (no more than 10) of the media to facilitate the load process.
34"
A0
36"