Quadra-Fire CASTINS-CSB - Manual (Page 2)

Page 2 250-7251G August 20, 2009
R Castile Pellet Insert
Hearth & Home Technologies welcomes you to our
tradition of excellence! In choosing a Quadra-Fire
appliance, you have our assurance of commitment
to quality, durability, and performance.
This commitment begins with our research of the
market, including ‘Voice of the Customer’ contacts,
ensuring we make products that will satisfy your
needs.
Our Research and Development facility then
employs the world’s most advanced technology
to achieve the optimum operation of our stoves,
inserts and fi replaces. And yet we are old-fash-
ioned when it comes to craftsmanship. Each unit
is meticulously fabricated and are hand-fi nished for
lasting beauty and enjoyment.
Our pledge to quality is completed as each model
undergoes a quality control inspection. From
design, to fabrication, to shipping: We wish you
and your family many years of enjoyment in the
warmth and comfort of your hearth appliance.
Thank you for choosing Quadra-Fire.
SAMPLE OF CLEARANCE TO COMBUSTIBLES LABEL
LOCATION: On beaded chain behind right access
panel. Panel hinges open.
Report No.
#061-S-42-2
7014-143
SAFETY LABEL
R
Castile Pellet Insert
Listed Solid Fuel Room Heater/Pellet Type Insert. Also suitable for Mobile Home Installation. This
appliance has been tested and listed for use in Manufactured Homes in accordance with OAR
814-23-9000 through 814-23-909.
Tested to: ASTM E-1509-95, ULC S628-93, ULC /ORD-C1482-M1990 Room Heating Pellet Burning Type,
(UM) 84-HUD FOR USE ONLY WITH PELLETIZED WOOD OR SHELLED FIELD CORN FUEL.
Route power cord away from unit. Do not route cord under or in front of appliance.
Input Rating: 30,000 BTU/HR.
Electrical Rating: 115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 AMPS.
MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS
AS A BUILT-IN UNIT
Masonry or Zero Clearance
DO NOT REMOVE THIS LABEL
A Insert side to combustible 0 in. 0mm
B Insert top to mantel 12 in. 305mm
C Insert top to face trim 0 in. 0mm
D Insert side face trim 0 in. 0mm
E Hearth extension from door opening 6 in. 152mm
F Hearth extension from side of door opening 6 in. 152mm
B
D C
C
A
B
E
0 in. Clearance To Exposed Section and Face Trim
A Top of Hopper Top/Rear Vent 0 in. (0mm)
B Side of Outside Skin Top/Rear Vent 0 in. (0mm)
C Back of Hopper Rear Vent 0 in. (0mm)
Top Vent 2.5 in. (64mm)
D Vent Pipe to Combustible Rear Vent 3.0 in. (76mm)
E From Panel Edge 0 in. (0mm)
SIDE W
ALL
MANTEL
B
A
C
E
D
F
Face Trim
1445 Highway North, Colville, WA 99114
Manufactured by:
www.quadrafire.com
O-T L Tested and
Listed by
Portland
Oregon USA
OMNI-Test Laboratories, Inc.
C US
SA
MPLE
This model is exempt from EPA certification
under 40 CFR 60.531 by definition [Wood
Heater (A) "Air-to-Fuel Ratio"].
JAN FEB MAR APR MAY JUNE JULY AUG SEPT OCT NOV DEC
250-7262F
CASTILE PELLET INSERT R SERIAL NO. / NUMÉRO DU SÉRIE
DO NOT REMOVE THIS LABEL Made in U.S.A.
Report / Rapport
#061-S-42-2
CAUTION :
ATTENTION:
HOT WHILE IN OPERATION DO NOT TOUCH, KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN
BURNS. SEE NAMEPLATE AND INSTRUCTIONS. Operate this unit with fuel hopper lid closed. Failure to do so may
result in emissions products’ combustion from the hopper under certain conditions. Maintain hopper seal in
good condition. Do not overfill hopper.
CHAUD LORS DE L'OPÉRATION. NE PAS TOUCHER. GARDEZ LES ENFANTS ET LES VÊTEMENTS LOIN DE
L'ESPACE DÉSIGNÉ DE L'INSTALLATION. LE CONTACT PEUT CAUSER DES BRÛLURES À LA PEAU. VOIR
L'ÉTIQUETTE ET LES INSTRUCTIONS.Opérez cet appareil avec le couvercle de la trémie fermé. Le défautde ne pas suivre les instructions
peut résulter, sous certaines conditions, en une combustion des émissions des produits venant de la trémie. Ne pas remplir la trémie trop pleine.
007
2009 2010 2011
U.S. ENVIRONMENTAL
PROTECTION AGENCY
NE PAS ENLEVER L'ÉTIQUETTE Fait Aux États-Unis
O-T L Tested and
Listed by
Portland
Oregon USA
OMNI-Test Laboratories, Inc.
C US
Test Lab &
Rpt Nbr. Mfg Date Model
Name Serial No.
SAMPLE OF SERIAL NUMBER & DATE OF MANUFACTURE LABEL
LOCATION: Inside hopper on the top
NOTE: Consult
insurance carrier, local
building inspector, fi re
offi cials or authorities
having jurisdiction over
restrictions, installation
inspection and permits.