Quadra-Fire CASTINS-CSB - Manual (Page 26)

Page 26 250-7251G August 20, 2009
R Castile Pellet Insert
The fuel adjustment control rod is factory set, and should be
adequate for most fuels.
The set screw is located at the bottom of the hopper and
set loose at the factory so the fuel adjustment control rod
will slide by only loosening the wing nut. Do not re-tighten
bottom set screw.
However, if the flame height is too high or too low, you will
need to adjust the feed rate. Wait until the appliance has been
burning for 15 minutes before making your adjustments and
allow 15 minutes for feed adjustment to take effect. Make
adjustments in approximately 1/2 inch increments.
1. Loosen the wing nut. Figure 26.1.
2. Adjust the fuel adjustment control rod towards the
"+" symbol to increase the feed rate and fl ame height or
towards the "-" symbol, to decrease the feed rate and fl ame
height.
3. Re-tighten the wing nut.
F. Feed Rate Adjustment
Figure 26.1
Control Box
Junction Box
Reset Button
Heat Output
Switch
Power Cord
Outlet
Thermostat
Block
Fuse
Red Call
Light
Red/Green Light
Blue Light
Wing Nut
"+"
"-"
G. Iginition Cycles
1. During each ignition cycle, it is normal to see some smoke
in the fi rebox. The smoke will stop once the fi re starts.
2. The convection blower will automatically turn on after your
appliance has reached the set temperature. This blower
transfers heat from your appliance into the room, and will
continue to run after the thermostat has stopped calling
for heat until the appliance has cooled down.
3. Occasionally the appliance may run out of fuel and shut
itself down. When this happens, the red call light will
be on. To restart it, fi ll the hopper and press the reset
button. Figure 26.2. When you press the reset button
the red call light will go out. Release the button and the
light will come back on. You should see a fi re shortly.
If not, follow the instructions on page 25, “Starting Your
First Fire”.
WARNING
Fire Risk
Do NOT operate appliance:
• With appliance door open.
• Firepot fl oor open.
• Cleaning slide plates open.
Do NOT store fuel:
• Closer than required clearances to com-
bustibles to appliance
• Within space required for loading or ash
removal.
Back side of Firepot
Firepot floor left open
Figure 26.2 - DO NOT LEAVE FIREPOT FLOOR OPEN
Figure 26.1