True Manufacturing Company TAC-36 - Manual (Page 11)

............ www.truemfg.com ............
True Food Service Equipment, Inc.
9 9
INSTALLATION / OPERATION INSTRUCTIONS
A. The compressor is ready to operate. Plug in the unit.
PLEASE REVIEW THE FOLLOWING CAUTIONS WHEN THE
OPTIONAL HEATED PAN IS USED.
CAUTION
This unit has two power supply cords. Unplug both
cords before moving or servicing this appliance.
CAUTION
This unit has two power supply cords. Connect
each plug to a receptacle that is connected to an
individual branch circuit.
CAUTION
This unit has more than one disconnect switch (plug).
B. Temperature control set at No. 4 position gives
refrigerators an approximate temperature of 33°F to 38˚F
(.5˚C to 3.3˚C). Allow unit to function several hours,
completely cooling cabinet before changing the control
setting.
C. Excessive tampering with the control could lead to service
difficulties. Should it ever become necessary to replace
temperature control, be sure it is ordered from your TRUE
dealer or recommended service agent.
D. Good air flow in your TRUE unit is critical. Be careful
to load product so that it neither presses against the back
wall, nor comes within four inches of the evaporator
housing. Refrigerated air off the coil must circulate down
the front of the shelves.
NOTE
If the unit is disconnected or shut off, wait five minutes before
starting again.
RECOMMENDATION
Before loading product we recommend you run your TRUE unit empty
for two to three days. This allows you to be sure electrical wiring
and installation are correct and no shipping damage has occurred.
Remember, our factory warranty does not cover product loss!
REPLACEMENT PARTS
TRUE maintains a record of the cabinet serial number for your unit.
If at any time during the life of your display case, a part is needed,
you may obtain this part by furnishing the model number and serial
number to the company from whom you purchased the cabinet. Call
Toll-Free: (800)-424-TRUE (Direct to Parts Department). (800)-325-
6152 (U.S.A. & Canada only) or call: (636)-240-2400.
LIGHT SWITCH LOCATION:
The light switch is located behind the interior light on the ceiling.
Depending on the model the switch will be either on the left or right
side of the ceiling.
STARTUP
Serial Number
• Remote cabinets must be ordered as remote.
We do not recommend converting a standard
self contained to remote system.
• All remote cabinets must be hard wired.
• Remote cabinets are not available with castors.
• All remote cabinets come standard using 404A refrig-
erant.
• All remote units come standard with expansion valve,
liquid line solenoid, heated condensate pan, and
defrost timer when applicable.
• Contact TRUE Technical Service for BTU require-
ments.
• No wiring necessary between cabinet and
condensing unit.
• All remote condensing units purchased from TRUE
are 208/230 volts single phase.
If you have any questions regarding this section, please
call TRUE at 1 (800) 325-6152.
REMOTE UNITS (This section applies to remotes only!)