Toshiba TEC MA-186 - Manual (Page 44)

- 38 -
EO1-11115
MA-186-100 SERIES
Dept.
To enter a sale item of the
Department Nos. 21 to 40
...
( ) DPT
SHIFT
DPT
SHIFT
. . .
. . .
. . .
@/FOR Dept.
Quantity
Unit Price
@/FOR
Quantity
REPEAT
→
Dept.
← ←
If an error occurs here:
Possible cause of error:
• Exceeding the LC of the Department
→
Check the Unit Price.
→
See Listing Capacity Open on
page 46.
• Product exceeding 7 digits.
→
Check the Quantity and Unit Price.
Dept.
Price; Max. 7 digits
. . .
REPEAT
← ←
→
If an error occurs here:
Possible cause of error:
• Product exceeding 7 digits.
→
Check the Quantity.
←
←
←
12. X
0.5 0 @
0 1 ★6.0 0
Quantity
Unit Price
Product TM
←
Department No.
Open-price Department (Nos. 21 to 40)
Depress the [DPT SHIFT] key at either position.
Preset-price Department (Nos. 21 to 40)
→ →
NOTE: A negative department cannot be repeated.
Quantity Extension (Multiplication)
Open-price Department
Depress the [DPT SHIFT] key at either position to enter a sale
item of the Department Nos. 21 to 40.
Preset-price Department
→ →
NOTES: 1. Quantity... Max. 6 digits (Max. 3 digits for integer + max. 3 digits for decimal. Use the [.] key if a
decimal portion is contained.)
Unit Price ... Max. 6 digits
Product (result of multiplication) ... Must not exceed 7 digits.
2. When the Quantity is 1-digit integer (1 to 9) and a Preset-price Department key follows, the [@/
FOR] key is omissible.
3. The decimal portion of the Quantity entry is processed down to the 2 digits below the decimal point.
The fraction rounding at this time is fixed to ROUND OFF.
4. You can select the rounding process of the fractions of the product —ROUND OFF (initial setting),
ROUND UP, or ROUND DOWN. (Refer to Chapter “16. System Option Setting”, Address 2 -
Bits 1 and 2 on page 72.)