Toshiba TEC MA-186 - Manual (Page 47)

- 41 -
EO1-11115
MA-186-100 SERIES
Programming PLUs
PLU Table Setting:
Condition: To change setting of a PLU: When the required PLU sales total memory is zero (i.e.,when no
sales are made or after a PLU Reset Report is taken to reset the sales data of the PLU into
zero)
To add new PLUs: Any time outside a sale.
(refer to “NOTE on Condition” on page 15)
Programming Procedure:
Use the MA Key to turn the Control Lock to “SET”.
Preset Price
max. 6 digits;
0
to 999999 ¢
To set Open-price PLU
NOTE 2
PLU Code max. 3 digits; 1 to
500
NOTE 1
Declaration of Program No.4
for PLU Table programming
* Repeat for programming other PLUs.
(Max. 500 PLUs)
( )
Depress the [DPT
SHIFT] key to
designate the
Department Nos.
21 to 40. Depress the key
of the Depart-
ment to which the
setting PLU is
linked.
NOTE 3
Z OFF
X
REG
SET
AT/TL Dept.
4 @/FOR
→
→
→
→
PLU
. . . DPT
SHIFT
AMT
*
→ →
→ → → → →
NOTES 1. When sequentially programming the PLUs, the code specification can be omitted. When it is
omitted at the very first PLU, PLU Code “1” is automatically assigned.
2. An Open-price PLU always requires a price entry through Numeric Keys in sale entries, and may
be used for an item that frequently changes its price.
3. The statuses (Positive/Negative Status, Tax (PST) 1 & 2 Status, GST Status, and Key Type
Status) of each PLU is decided by the statuses of the statuses of the Department to which the PLU
is linked.
4. When a PLU is linked to an Other Income Department, an entry of the PLU in a sale will cause an
error.