Tally Genicom Matrix Printer - Manual (Page 313)

➊ Paper is ejected also by FF or the limit, fixed by the form length or the bottom margin.
➋ This sequence selects manual cut sheet paper process.
➌ This sequence selects fanfold paper process for tractor 1.
➍ This sequence selects fanfold paper process for optional tractor 2. If an optional tractor 2
is installed, sequences for selecting the automatic single sheet feeder (ASF) are ignored.
➎ Selection of bin 1 or 2.
Vertical alignment of the first printable line in steps of n
1 ⁄
72 inch downwards is optional.
n is set to 12 ⁄
72 inch (one line at 6 lpi) in the default menu.
➏ Depending on the hardware, up to 9 bins can be selected.
(bin 1 - 9
=
∧
CSI 21 - CSI 29).
➐ Depending on the hardware and in the case a sorter has been installed, up to 19 exit
ports can be selected.
(stacker 1 - 19
=
∧
CSI 31 - CSI 49).
➑ The page is set from view or tear-off position (perforation) to print position.
This means, that the print head moves to the current position or to the first possible
line of the following document.
➒ Independent of the menu settings the paper is set to tear-off position.
This sequence has no affect, if the respective position is just set manual (by means of
the “Tear” key) or automatically (printer menu setting: Parameter group “Auto Tear”).
**)
➓ Independent of the menu settings the paper is set to view position (last printed line).
This sequence has no affect, if the respective position is just set manual (by means of
the “Tear” key) or automatically (printer menu setting: Parameter group “Auto Tear”).
➀ This sequence is only available if an optional cutter is installed and cuts fanfold paper
at the next perforation.
*)
➁ This sequence is only available if an optional cutter is installed; it cuts above the
current line, if the text to be printed was ended with a CR (hex. 0D, dec. 13), it cuts
below the line, if the text to be printed was ended with a LF (hex. 0A, dec. 10).
The sheet feeder - if installed and connected - has to be selected via the menu of the
printer (refer to the Operator’s Manual).
*) If a cutting device is installed.
**) If no cutting device is installed.
Miscellaneous 77