Step 4: installing anti-tip device – Thermador PRG30 User Manual

Page 11

Advertising
background image

English 9

Remove the outer carton and packing material from the

shipping pallet. The all gas ranges are held to the pallet

by four (4) bolts (see Figure

5). The two front pallet

bolts are accessible only after removing the Kick Panel.

Remove the two screws below the lower corners of the

oven cavity and lift the Kick Panel away from the two

projections on the range‘s cast base that capture the

bottom edge of the Panel. After removing the bolts, the

range must be lifted and removed from the pallet.

CAUTION:

DO NOT lift the range by the oven door's

handle, as this may damage the door hinges

and cause the door to fit incorrectly to the oven

cavity.

Note:

Leave adhesive-backed foam layer over brushed-metal

surfaces, to protect finish from scratches, until the range is

installed in its final position.

Due to the weight, a dolly with soft wheels should be

used to move this unit. The weight must be supported

uniformly across the bottom (See Figure

6).

After transporting the range by dolly close to its final

location, the range can be tipped back and supported

on the rear legs while the dolly is carefully removed.

THE FLOOR UNDER THE LEGS SHOULD BE

PROTECTED BEFORE PUSHING THE UNIT INTO

POSITION. The anti-tip device must be installed

(STEP 4), gas and electrical connections should be

made (STEPS 5 and 6), and the backguard installed

(STEP 7) before the range is placed in its final position.

Do not install the oven door(s) until the range is in its

final location.

Remove all tape and packaging before using the appliance.

Destroy the packaging after unpacking the appliance.

Never allow children to play with packaging material.

Step 4: Installing Anti-Tip

Device

Fo

r all 30" and 36" ranges, a

n anti-tip device must be

installed per these instructions.

WARNING — RANGE TIPPING

HAZARD

All ranges can tip and injury can result. To

prevent accidental tipping of the range,

attach it to the floor, wall or cabinet by

installing the Anti-Tip Device supplied.

A risk of tip-over may exist if the appliance

is not installed in accordance with these

instructions.

If the range is pulled away from the wall for

cleaning, service or any other reason,

ensure that the Anti-Tip Device is properly

Chart A

30"

Range

36"

Range

48"

Range

Shipping Weight

300 lbs.

335 lbs.

534 lbs.

Weight without

packing materials

265 lbs.

300 lbs.

469 lbs.

Without door(s),

burner caps, front

kick panel and oven

racks

142 lbs.

207 lbs.

322 lbs.

Figure 5: Removal of the Four (4) Shipping Bolts

Pallet

Figure 6: Dolly Positioning

Range

Must be

Uniformly

Supported

by Braces

Provided

on Bottom

of Range

Advertising
This manual is related to the following products: