Thermador PRG30 - Manual (Page 16)

English 14
Important:
Dedicated 20 AMP service is required for range with
electric griddle.
Step 7: Backguard Installation
• The backguard must be attached before sliding the
range into the final, installed position. A Low Back or
Pot-and-Pan Shelf must be installed when there is less
than 12" clearance from a combustible back wall and
the back of the range above the cooking surface.
• A Flush Island Trim is available for covering the back
area of the range for island installations; however, the
Flush Island Trim can only be used where there is a
minimum of 12" horizontal clearance between a
combustible back wall and the back of the range.
• The backguard is inserted inside the guide channels on
the back of the range, as shown in the illustration.
(Remove the griddle plate for sufficient installation
clearance on griddle models.) Using a T-20 size Torx
driver, fasten the backguard with four (4) Torx-head
screws to the range‘s side panels, two (2) screws to the
range‘s back panel, and four (4) screws to the area
around the cooling blower.
• To secure the front of the backguard, install three (3) of
the Torx head screws through the lower front panel of
the backguard, into the flange at the back of the
range’s cooktop.
• The Pot-and-Pan Shelf requires pre-assembly of the
top panel to the shell using nine (9) of the enclosed
Torx-head screws. For sufficient load strength, YOU
MUST attach the two (2) Torx-head screws through the
back corners of the top down into the shell.
• The Pot-and-Pan Shelf provides a shelf above the
cooktop to keep foods hot or store cooking pans.
OBSERVE CAUTIONS.
WARNING
Fingers or hand could get pinched when
installing the backguard. Severe injury could
result. Use extreme caution and wear thick
protective gloves to avoid potential cut or
laceration to finger or hand while sliding the
backguard down onto the range.
WARNING
To avoid possible burn or fire hazard, a
backguard designed specifically for this range
must be installed whenever the range is used.
CAUTION
The Pot and Pan Shelf can get very hot! DO
NOT place the following items on top of the Pot
and Pan Shelf:
• plastics or containers that can melt
• flammable items
• a total load over 30 pounds (13.6kg)
Figure 11: Backguard Installation
The back panel of backguard is positioned inside
these two guide channels on the back of the range.
Front of Range
Chart C: Backguard Kit Model Numbers
Range Width 6" Std. Low Back 9" Low Back
22" Pot and Pan
Shelf
Flush Island Trim
30" Included with Range N/A PA30GHSH PA30GITH
36" N/A PA36GLBH PA36GHSH Included with Range
48" N/A PA48GLBH PA48GHSH Included with Range