UTStarcom 860 - Manual (Page 17)

Making a Call
Enter the area code and the phone number to make a call in
the Standby mode, then press the [ ] key.
To clear the last digit displayed, press the [ ] key.
To clear all digits displayed, press and hold the [ ] key.
Ending a Call
To finish your call, press the [ ] key.
Once the call is completed, the call summary (Receiver
Name or Number, Service Time) will be displayed.
Using Call Logs
The phone stores up to 40 dialed, received or missed calls
reverse chronologically. The last call is saved in the first
position. If the same number is dialed more than once,
only the last occurrence will be saved.
1 Press the down Navigation Key to see the call log of dialed,
received or missed numbers In reverse chronological order.
2
Press the [ ]/[ ] key to select a number.
33
Making a Call
Attempts to make a call by adding ‘1’ before the number entered if
Auto Prepend is On. (If the number entered begins with 1, it will not
add ‘1’ to it.)
NOTE:
32
Switching the Phone On or Off
Switching the Phone On
1 Press and hold the [ ] key until the phone switches on.
Your phone starts to search for the available network, and
the current date and time appear on the LCD display.
Once connected to the network, you can send or receive
calls.
If the malfunction occurs while using the phone or it is not
turned on, remove the battery and install it again after 5 or 10
seconds.
Switching the Phone Off
To switch the phone off, press and hold the [ ] key until
the power-off animation displays.