UTStarcom 860 - Manual (Page 29)

57
Using Voice Dial
Use the VOICE DIAL command to dial any number
stored in your contact list by saying the name of the
contact (Name Dialing).
You can also use VOICE DIAL to dial any valid
telephone number, even numbers not stored in your
contact list, by saying the digits (Digit Dialing).
Dialing a Name
To Dial a Name Using Voice Dial:
1 Start VOICESIGNAL.
2 Say “VOICE DIAL”.
VoiceSignal prompts you to “Say the name or number.”
3 Speak clearly and say the name of a person in your contact
list, first name followed by last name.
For example, say “Phil Johnson.”
If VoiceSignal recognizes the name and there is a number
stored with that name, VoiceSignal repeats the name and
dials the number.
If VoiceSignal is not sure of the name you said, it displays a
choice list of up to three names and prompts you with “Did
you say?” followed by the first name on the list.
VoiceSignal
56
VoiceSignal
Ending Calls Before Restarting The VoiceSignal
Software
When you use VoiceSignal to make a call, you must end the
call before using the VoiceSignal application again.