Operating instructions, Reset function – Villaware INSTRUCTION MANUAL FPVLJESLO1 User Manual

Page 7

Advertising
background image

6

operating instructions

1

. Your juicer features an extra wide chute so most fruits and vegetables, such as smaller

apples, carrots and tomatoes, will not need to be cut into smaller pieces since they fit

directly into the chute.

2. Prepare your fruits and vegetables by washing them thoroughly and peeling those that

need the skin removed.

3. Ensure the juice extractor and its accessories are clean by following the “cleaning” and

“maintenance” sections of this manual.

4. Make sure your juice extractor is properly assembled. Please follow the instructions from

the section “BEFORE USING YOUR JUICE EXTRACTOR.”

5. Place the cup or any other container/glass you wish to use to collect the juice under the

spout and make sure the pulp collector is in place prior to juicing. Do not overfill the pulp

collecting container as this may cause the unit to stall.

6. Plug the power cord into an electrical outlet and turn the power on. Select “

” (low

speed) for soft foods or “

” (high speed) for hard foods.

7. Turn the unit on before inserting foods. Once the juicer is on, place fruits and/or

vegetables in the food chute and use the food pusher to slowly drive them down. In

order to extract the maximum amount of juice, it is important to push the food pusher

slowly.

8. The juice extractor will separate the juice into the cup and the pulp into the pulp

collector while you are juicing. Both the pulp container and the cup can be emptied

during juicing by turning the juice extractor off “

”. Make sure to place both

containers back into place before you resume juicing.

WARNING: NEVER USE HANDS OR FINGERS TO PUSH FOOD DOWN THE FOOD

CHUTE OR TO CLEAR THE FOOD CHUTE. ALWAYS USE THE FOOD PUSHER

PROVIDED.

Reset Function

1

. The motor contains a resettable fuse to protect against overheating.

2. If the unit stops after continuous use, turn the juice extractor off “

” and unplug it

from the electrical outlet.

3. Wait 5-

1

0 minutes for the juice extractor to cool down.

4. Plug the juice extractor into the electrical outlet and resume normal use.
5. If the juice does not operate after instructions

1

-4, repeat the above steps and wait a

further

1

0 minutes before using again.

Advertising