Vision Fitness Simple and Deluxe - Manual (Page 51)

47
GENERAL
TROUBLESHOOTING YOUR TREADMILL
Our Treadmills are designed to be reliable and easy to use. If, however,
you have a problem, these troubleshooting steps may indicate the cause.
PROBLEM: The Console does not light up.
SOLUTION: Check to make sure the Treadmill is connected to a
functioning outlet, and that the Treadmill is turned on.
PROBLEM: The Treadmill’s built-in circuit breaker trips repeatedly,
shutting-off for no apparent reason.
SOLUTION: The lubricating wax coating on the deck is wearing down
and needs to be replenished; contact your VISION FITNESS retailer.
PROBLEM: The Treadmill shuts off when elevated.
SOLUTION: Check to make sure that the power cord is not stretched so
tight that when the Treadmill is elevated the cord is pulled out of the wall
outlet.
PROBLEM: The running belt does not stay in the center of the Treadmill
when you are running on it.
SOLUTION: Check to make sure the Treadmill is level.
SOLUTION: The running belt is loose and needs to be properly tensioned
(see Page 49 for proper procedure).
PROBLEM: The belt moves within 1/4” of -- but does not touch -- the side rail.
SOLUTION: There is nothing wrong, this is normal and will not cause any
damage.
PROBLEM: An error message appears. An error message is designated by
the letter “E” and a number, (ex. “E5”).
SOLUTION: Contact your VISION FITNESS retailer.
NOTE:
If the above steps do not remedy the problem, discontinue use, turn
the power off and contact your VISION FITNESS retailer.