Vxi backplane connections 5-8, Power supplies and ground 5-8, Data transfer bus 5-8 – VXI VT1433B User Manual
Page 116: Dtb arbitration bus 5-8, Priority interrupt bus 5-8, Utility bus 5-8, Vxi backplane connections
VXI Backplane Connections
Power Supplies and Ground
The VT1433B conforms to the VME and VXI specifications for pin assignment.
The current drawn from each supply is given in the specifications chapter.
Data Transfer Bus
The VT1433B conforms to the VME and VXI specifications for pin assignment
and protocol. A16, A24, D16 and D32 data transfers are supported.
DTB Arbitration Bus
The VT1433B module is not capable of requesting bus control. Thus it does not
use the Arbitration bus. To conform to the VME and VXI specifications, it
passes the bus lines through.
Priority Interrupt Bus
The VT1433B generates interrupts by applying a programmable mask to its status
bits. The priority of the interrupt is determined by the interrupt priority setting in
the control register.
Utility Bus
The VME specification provides a set of lines collectively called the utility bus.
Of these lines, the VT1433B only uses the SYSRESET* line.
Pulling the SYSRESET* line low (a hardware reset) has the same effect as setting
the reset bit in the Control Register (a software reset), except that pulling the
SYSRESET* line low also resets the Control Register itself, while a software
reset does not.
VT1433B User's Guide
Module Description
5-8