VXI VT1433B - Manual (Page 26)

The buttons on the right side of the SFP display are defined as follows:
Meas
This button opens the Measurement Control dialog box. It can set:
q Measurement single/repeat
q Mode block/continuous
q Trigger auto/manual/input/source
q Frequency span
q Blocksize
Input
This button opens a dialog box where the VT1433B’s inputs can be setup. It can
set:
q Channel number
q Range
q AC or DC coupling
q Grounding method
q Digital anti-alias filter
q Analog anti-alias filter
q Trigger on/off
q Trigger mode level/bound
q Trigger level
q Hysteresis
q Trigger Slope
There is a checkbox to make all channels identical.
Source
This opens a dialog box for controlling the source output of the VT1433B’s
source. This is only available for VT1433B’s that have the Arbitrary Source
VT1433B-1D4. It can set:
q Channel number
q Active on/off
q Mode sine/burst sine/random/burst random
q Ramp rate
q Sine frequency
q Sine phase
q Output normal/grounded/open/cal/multi
q Trigger on/off
q Cola (Constant Output Level Amplifier) off/on
q Duty Cycle
q Sum off/on
q Seed
q Range
VT1433B User's Guide
Getting Started With the VT1433B
2-8