VTech LS6426-3 - Manual (Page 32)

28
Multiple handset use
PTT to a single handset
You have two ways to begin a PTT call:
If you have two handsets, press and hold PUSH TO TALK when the
handset is not in use.
If you have more than two handsets, press
PUSH TO TALK when the
handset is not in use. Then use the dialing keys to enter a handset number
( 1-9 for handsets 1-9, and 0 for handset 10, and 1 for handset 11 or
and 2 for handset 12), or press or to scroll to the desired handset
then press
MENU
/SELECT. Press
MENU
/SELECT or PUSH TO TALK to
create the push-to-talk session.
Your handset displays Connecting to HANDSET X... for a few seconds. When
the connection is made, both the originating and the destination handsets
display Press and hold [PTT] to talk and beep once.
Press and hold PUSH TO TALK on your handset. A chirp indicates your
microphone is on. Speak towards the handset. Your voice is broadcast to the
destination handset. While you are speaking, your handset displays
PTT To handset X (X represents the destination handset).
Release PUSH TO TALK after speaking. Both handsets beep once again.
After the handsets beep, you can press and hold PUSH TO TALK to continue
speaking or the destination handset can respond (see Answer a PTT call on
page 30).
Press
OFF/
CANCEL
to end the PTT call. The handset displays Push to talk Ended
for a few seconds.
-OR-
Place the handset in the telephone base or charger to end the PTT call.
After PUSH TO TALK is released, the PTT call remains open for a short time. If no
one presses PUSH TO TALK within 10 seconds, the PTT call ends automatically.
1.
•
•
2.
3.
4.