VTech LS6426-3 - Manual (Page 35)

31
Multiple handset use
End a PTT call
For a one-to-one PTT call, both the originating and destination handsets can
end the PTT call.
For a PTT call to multiple handsets, the originating handset can end the
PTT call. If any one of the destination handsets leaves the PTT call, the call
continues until all handsets hang up.
To end or leave a PTT call:
Press OFF/
CANCEL
or place the handset in the telephone base or charger. The
handset displays Push to talk Ended.
After PUSH TO TALK is released, the PTT call remains open for a short time. If no
one presses PUSH TO TALK within 10 seconds, the PTT call ends automatically.
Answer an incoming call during a PTT call
When you receive an incoming outside call during PTT, there is an alert tone.
During a one-to-one PTT call, press /
FLASH
on the originating or destination
handset. The PTT call ends automatically and the outside call is answered.
During a PTT call to multiple handsets, press
/
FLASH
on the originating
handset. The PTT call ends automatically and the outside call is answered.
During a PTT call to multiple handsets, press
/
FLASH
on any one of the
destination handsets and that handset answers the outside call. The PTT call
continues for the rest of the PTT participants.
To leave the PTT call without answering the incoming call, press
OFF/
CANCEL
.
The telephone continues to ring.
Make an outgoing call during a PTT call
During a one-to-one PTT call, press /
FLASH
to get a dial tone. The PTT call
ends automatically.
During a PTT call to multiple handsets, press
/
FLASH
on the originating
handset. The PTT call ends automatically and you get a dial tone.
During a PTT call to multiple handsets, press
/
FLASH
on any one of
the destination handsets and that handset gets a dial tone. The PTT call
continues for the rest of the PTT participants.
•
•
•
•
•
•
•
•
•
•