Wayne-Dalton TORSION SPRING 9800 User Manual
Page 13
Please Do Not Return This Product To The store. Call us Directly! Our trained technicians Will answer your questions and/or Ship any Parts
you May Need. you can reach us toll free at
1-888-827-3667 for Consumer assistance or online at www.wayne-dalton.com
13
tools Needed:
tools Needed:
IN
sT
All
ATION
Counterbalance Cables
None
bOttOM
SECtION
aStRaGal
4
IMPORTANT: RIGht aND lEft haND IS
alWayS DEtERMINED fROM INSIDE thE
GaRaGE lOOkING Out.
NOTE: for door section identification see
page 4.
uncoil the counterbalance cables and
slip the loop at the ends of the cables
over each milford pin on the bottom
section.
Insert a roller into bottom bracket of the
bottom section and insert another roller
at #1 end hinge at the top of the bottom
section. Repeat for other side.
NOTE: Verify astragal (bottom seal)
is aligned with door section. If there
is more than 1/2” excess astragal on
either side, trim astragal even with door
section.
3
bOttOM SECtION
MIlfORD PIN
ROllERS
#1 END
hINGE (hINGE
tubE)
bOttOM bRaCkEt
bOttOM
SECtION
COuNtERbalaNCE
CablE
bottom section
before installing the bottom section,
the weather seal (may not be included)
must be installed (see PREPaRING thE
OPENING on page 10)
Center the bottom section in the door
opening. level section using wooden
shims (if necessary) under the bottom
section.
level
bOttOM
SECtION
DOOR OPENING
WEathER SEal
WOODEN ShIMS
(If NECESSaRy)
lEVEl