Wayne-Dalton TORSION SPRING 9800 - Manual (Page 3)

Please Do Not Return This Product To The store. Call us Directly! Our trained technicians Will answer your questions and/or Ship any Parts
you May Need. you can reach us toll free at 1-888-827-3667 for Consumer assistance or online at www.wayne-dalton.com
3
Package Contents
NOTE: DEPENDING ON thE DOOR MODEl, SOME PaRtS lIStED
WIll NOt bE SuPPlIED If NOt NECESSaRy. REaR SuPPORtS
May OR May NOt bE INCluDED WIth yOuR DOOR.
© Copyright 2006 Wayne-Dalton Corp. Part No. 326091 NEW 05/08/2006
Torsion Spring
Installation Instructions and Owner’s Manual
Portland Source Plant
IMPORTANT NOTICE! Read these instructions carefully before
attempting installation. If in question about
any of the procedures, do not perform the
work. Instead, have a qualified door agency
do the installation or repairs.
9800 Series
MaNual (1) CENtER bRaCkEt
buShING
RIGht aND lEft
COuNtERbalaNCE CablES
RIGht & lEft
END bEaRING bRaCkEtS
(1) CENtER bRaCkEt
RIGht & lEft
DRuMS
Rh/lh tORSION
SPRINGS (aS REquIRED)
(2) 3/8”- 16 x 1-1/2” hEx hEaD bOlt 5/16” x 2” taMPER RESIStaNt laG
SCREW (aS REquIRED)
(1) tORSION tubE
DOOR SECtIONS (aS REquIRED)
(2) tOP bRaCkEt
baSES
(1) OPERatOR bRaCkEt (2) tOP bRaCkEt
SlIDES
SCREW EyE & Pull
ROPE (If INCluDED)
ROllERS
(aS REquIRED)
WEathER SEal & NaIlS
(If INCluDED)
DOOR StOP & NaIlS
(If INCluDED)
jaMb bRaCkEtS
(aS REquIRED)
(2) hORIzONtal tRaCkS WIth attaChED hORIzONtal aNGlE Rh/lh
(2) VERtICal
Rh/lh tRaCkS
1/4”- 14 x 5/8” SElf taPPING
SCREWS (aS REquIRED)
1/4”- 20 x 7/8” SElf DRIllING
SCREWS (aS REquIRED)
(2) 3/8”- 16
hEx NutS
1/4”- 20 flaNGE hEx
NutS (aS REquIRED)
1/4”- 20 x 5/8” CaRRIaGE
bOltS (aS REquIRED)
(2) 3/8”- 16 x 3/4”
hEx hEaD bOltS
5/16” x 2” hEx hEaD laG SCREWS (aS REquIRED)
(2) fully aDjuStablE
Rh/lh flaGaNGlES