Wayne-Dalton TORSION SPRING 9800 - Manual (Page 19)

Please Do Not Return This Product To The store. Call us Directly! Our trained technicians Will answer your questions and/or Ship any Parts
you May Need. you can reach us toll free at 1-888-827-3667 for Consumer assistance or online at www.wayne-dalton.com
19
IN
sT
All
ATION
tools Needed:
tools Needed:
Attaching horizontal Track to Adjustable
flagangle
to install horizontal track, place the curved end over
the top roller. align the bottom of the horizontal track
with the vertical track. hand tighten the horizontal
track to the flagangle with (2) 1/4”- 20 x 5/8” carriage
bolts and (2) 1/4”- 20 flange hex nuts.
level the horizontal track assembly and bolt the
horizontal angle to the slot in the flagangle using
(1) 3/8”- 16 x 3/4” hex head bolt and (1) 3/8”- 16 hex
nut. Repeat for other side. Remove the nail that was
temporarily holding the top section in place, installed
in Step 9.
IMPORTANT: faIluRE tO REMOVE NaIl bEfORE
attEMPtING tO RaISE DOOR COulD CauSE
PERMaNENt DaMaGE tO tOP SECtION.
DO NOt RaISE DOOR uNtIl hORIzONtal
tRaCkS aRE SE CuRED at REaR, aS
OutlINED IN StEP 19, OR DOOR COulD fall
fROM OVERhEaD POSI tION CauSING SEVERE
OR fatal INjuRy.
10
9/16” Socket
7/16” Socket
Ratchet Wrench
9/16” Wrench
level
hammer
WARNING
(1) 3/8”- 16 x 3/4”
hEx hEaD bOlt
(1) 3/8”- 16
hEx Nut
hORIzONtal
tRaCk
hORIzONtal aNGlE
flaGaNGlE
(2) 1/4”- 20 flaNGE
hEx NutS
VERtICal tRaCk
hORIzONtal
tRaCk
(2) 1/4”- 20 x 5/8”
CaRRIaGE bOltS
With horizontal tracks installed, you can
now adjust the top brackets. Vertically
align the top section of the door with the
lower sections. Once aligned, position
the roller in the top bracket slide, out
against the horizontal track.
Maintaining the slide’s position, tighten
the (2) 1/4”- 20 flange hex nuts to
secure the top bracket slide to the top
bracket base. Repeat for other side.
11
Adjusting Top brackets
hORIzONtal
tRaCk
tOP
bRaCkEt
SlIDE
(2) 1/4”- 20
flaNGED hEx
NutS
CORRECt
INCORRECt
tOP
ROllER
tOP
SECtION
tOP
SECtION
tOP
SECtION
7/16” Wrench