Wayne-Dalton TORSION SPRING 9800 - Manual (Page 30)

Please Do Not Return This Product To The store. Call us Directly! Our trained technicians Will answer your questions and/or Ship any Parts
you May Need. you can reach us toll free at 1-888-827-3667 for Consumer assistance or online at www.wayne-dalton.com
30
Painting Continued....
2. If the finish painted steel door surface has a textured surface representing wood grain, stucco, etc., this step should not be
attempted as danger of exposing substrate is greatly increased.
3. Consult a professional coatings contractor if in doubt about any of the above directions.
4. follow directions explicitly on the paint container labels for proper applications of coatings and disposal of containers. Pay particular
attention to acceptable weather and temperature conditions in which to paint.
fiberglass garage door finishing directions.
1. It is recommended that the doors be purchased pre-finished due to the size of the door, required spray equipment and quality
problems that could result. Wayne-Dalton assumes no liability for non-factory finished doors.
2. If finishing is preformed, use exterior commercial grade finishing kits approved for use on fiberglass or commercially available
exterior grade water based or oil based paint. the customer assumes all liability for the finishing.
3. the top coat on factory finished doors may require a re-coat after 1-3 years if the surface appears chalky or faded. Reapply a top
coat as follows: (always test on a small area prior to top coating the entire door)
a. Clean surfaces with soap and water or wipe down with mineral spirits or Naptha. light scuff sanding may be required using
Scotch-brite.
b. apply a commercial brand of exterior grade top coat following the manufacturer instructions.
4. to strip the existing coating from the door, use a commercial grade paint stripping products.
5. to paint over the existing paint, clean per the instructions listed above and apply any commercially available exterior grade water
based or oil based paint.