Wayne-Dalton TORSION SPRING 9800 - Manual (Page 25)

Please Do Not Return This Product To The store. Call us Directly! Our trained technicians Will answer your questions and/or Ship any Parts
you May Need. you can reach us toll free at 1-888-827-3667 for Consumer assistance or online at www.wayne-dalton.com
25
tools Needed:
IN
sT
All
ATION
Rear support
kEEP hORIzONtal tRaCk
PaRallEl aND WIthIN 3/4”
MaxIMuM Of DOOR EDGE,
OthERWISE DOOR COulD fall,
RESultING IN SEVERE INjuRy OR
DEath.
Raise the door until the top section and
half of the next section are in a horizontal
position. Do not raise door any further
since rear of horizontal track is not yet
supported.
RaISING DOOR fuRthER CaN
RESult IN DOOR fallING aND
CauSE SEVERE INjuRy OR DEath.
Clamp a pair of vice clamps on the
vertical tracks just above the second
roller on one side, just below the second
roller on the other side. this will prevent
the door from raising or lowering while
installing the rear support.
using perforated angle, 5/16” x 1-5/8”
hex head lag screws and 5/16” bolts
with nuts (may not be supplied), fabricate
rear support for horizontal tracks. attach
horizontal tracks to the rear supports
with 5/16”- 18 x 1-1/4” hex bolts and
nuts (may not be supplied). horizontal
tracks must be level and parallel with
door.
NOTE: If rear supports are to be installed
over drywall, use 5/16” x 2” hex head lag
screws.
adjust weather seal or door stop (if
necessary) Now permanently attach the
weather seal or door stop to both door
jambs and header. (temporarily attached
in PREPaRING thE OPENING on page 10.)
avoid pushing weather seal or door stop
too tightly against face of door.
PRIOR tO WINDING OR MakING
aDjuStMENtS tO thE SPRINGS,
ENSuRE yOu’RE WINDING IN thE
19
WARNING
WARNING
Ratchet Wrench
1/2” Socket
1/2” Wrench
(2) Vice Clamps
DOOR IN thE
uP POSItION
VERtICal
tRaCk
3/4”
VICE
ClaMPS
DOOR EDGE
hORIzONtal tRaCk
WARNING