Wayne-Dalton TORSION SPRING 9800 - Manual (Page 20)

Please Do Not Return This Product To The store. Call us Directly! Our trained technicians Will answer your questions and/or Ship any Parts
you May Need. you can reach us toll free at 1-888-827-3667 for Consumer assistance or online at www.wayne-dalton.com
20
tools Needed:
tools Needed:
Torsion End bearing brackets
End bearing brackets are right and left.
using the upper slots in the end bearing
bracket, position above the flagangle
and secure the end bearing bracket to
the horizontal angle using
(2) 3/8”- 16 x 3/4” hex head bolts and
(2) 3/8”- 16 nuts.
Once the bracket is secured to the
horizontal angle, secure the top of the
end bearing bracket to the jamb using
(2) 5/16” x 2” lag screws. Repeat for
other side.
NOTE: Right and left hand is always
determined from inside the garage
looking out.
Power Drill
7/16” Socket
Driver
9/16” Socket
Ratchet Wrench
9/16” Wrench
lEft END bEaRING bRaCkEt
hORIzONtal aNGlE
(2) 5/16” x 2”
laG SCREWS
(2) 3/8”-16 x 3/4”
hEx hEaD bOltS
(2) 3/8”-16
hEx NutS
Center bearing bracket
Power Drill
7/16” Socket
Driver
level
tape Measure
Pencil
1/4” torx bit
Measure to locate the center of the door
and mark a vertical pencil line on the
mounting surface above the door, to
indicate the center line of the door. then,
measure from the center of the bearing, in
one of the end bearing brackets, DOWN to
the top of the door. using that dimension,
measure uP from the top of the door
and mark a horizontal pencil line on the
mounting surface, intersecting the vertical
pencil line. Now align the edge of the
center bearing bracket along the vertical
pencil line on the mounting surface. Center
the bearing bracket on the horizontal
line. this will ensure the torsion tube is
level between the center and end bearing
brackets. attach the center bearing bracket,
in this location, to the mounting surface,
using (2) 5/16” x 2” lag screws and
(1) 5/16” x 2” tamper-resistant lag screw.
IMPORTANT: uSE thE 5/16” x 2” taMPER-
RESIStaNt laG SCREW ONly If MOuNtING
SuRfaCE MOuNtED OVER MaSONRy.
taMPER-RESIStaNt laG SCREW MuSt bE
attaChED thROuGh thE bOttOM hOlE
Of thE CENtER bEaRING bRaCkEt.
VERtICal lINE
MOuNtING SuRfaCE
Equal DIStaNCE
CENtER Of
END bEaRING
bRaCkEt
hORIzONtal lINE
CENtER bEaRING
bRaCkEt
CENtER
bEaRING
bRaCkEt
(2) 5/16” x 2”
laG SCREWS
MOuNtING
SuRfaCE
hORIzONtal lINE
VERtICal
lINE
12
13
(1) 5/16” x 2”
taMPER-RESIStaNt laG SCREW
OR (1) 5/16” x 2” laG SCREW